中国产一级古装毛卡片

Location: home »Working instruction for Bick Stacker

Working instruction for Bick Stacker


(The capacity is 60million-80million)
 
Full-automatic wet brick setting system is mainly suitable for once and twice bricks stacking in the tunnel kiln. It is used the advanced PLC central control, walks revolving are used the frequency conversion control. The lifting clamps are used the hydraulic control. The separator utilize digital technique, which has the highly effective energy conservation, simple maintain, the lowest inexpensive, movement reliable and other characteristics. Full-automatic wet bricks setting system is representing the present international advanced level.
 
The Full-automatic brick setting machine is formed by strip cutting machine, blank cutting machine, separating machine, chuck machine, waking car system, lifting system, rotation system, hydraulic system and electrical system.
 

The operating principle of full-automatic brick setting machine:

When the cutter pushed the wet bricks to the separating board, the separating cylinder pushed out the drive the brick to be cut. when the brick sub-section has been finished, the Lift Cylinder down. When the chunk reaches to the location of the scheduled blank, Chunk Fixture works in the way of the picking up the bricks, and then the chunk is highly lifted by the Lifting Cylinder to a predetermined height. After all of those progress, then separating cylinder point out and open the air channel and walking device drives blank stacking machine to the top of a kiln car, the kiln car turned to 90* and then lift cylinder dropped down to the schedule height for releasing billet, the chuck open and lay the blanks on the kiln car, it completes stacking process automatically, through all the cycle to  completes all the stacking work, all these function are centralized control by the advanced PLC central control. 
    Your Contact Details To Us    
(*)Required information

CopyRight@ 2012

WANGDA MACHINE FACTORY| All Rights Reserved
 
中国产一级古装毛卡片